Skip to main content
To MTA.info homepage
 

TRUCK/COMMERCIAL VEHICLE INFORMATION

Truck

Welcome. This page is designed to provide commercial operators with information about MTA Bridges and Tunnels rules and regulations at our crossings. Our facilities include: Bronx-Whitestone, Cross Bay Veterans Memorial, Henry Hudson, Marine Parkway-Gil Hodges Memorial, Throgs Neck, Robert F. Kennedy and Verrazano-Narrows Bridges, as well as the Queens Midtown Tunnel and Brooklyn-Battery Tunnel.

 

PLEASE NOTE THE FOLLOWING IMPORTANT INFORMATION:

Trucks are NOT permitted across the Henry Hudson Bridge at any time.

Overweight vehicles are NOT permitted at the Bronx-Whitestone Bridge at this time.

Weight Restrictions:
 All vehicles must be in compliance with the New York State Bridge Formula and cannot exceed 80,000 lbs. GVW (gross vehicle weight) at any MTA Bridges and Tunnels crossing, with the exception of certain vehicles that possess certain permits at the Throgs Neck Bridge. Please see Throgs Neck Bridge section below.
For more detailed information on the New York State Bridge Formula, please click on the following link: NYS DOT Overweight Vehicle Information and scroll to bottom of the first page.

Procedures for Overweight Vehicles

There are now separate procedures for overweight trucks carrying non-divisible and divisible loads as set forth below.  Please note that MTA permits are only valid on MTA facilities and do not apply to travel routes under city and state jurisdiction, which have separate permits. Be aware that for the safety of all our customers, Bridge and Tunnel Officers at MTA facilities perform routine checks on trucks. Drivers who do not comply with MTA Bridges and Tunnels’ rules face fines that may exceed $10,000. 

Non-Divisible Loads (*Note: This is A New Procedure)

*Vehicles carrying non-divisible loads that are over 80,000 lbs GVW and vehicles that are less than 80,000 lbs but are NOT in compliance with the State Bridge Formula must obtain a daily over–dimensional permit from the New York City Department of Transportation (NYCDOT) before attempting to cross any MTA Bridges and Tunnels facility. No separate MTA permit will be issued in conjunction with a NYCDOT permit for non-divisible loads.

For information on obtaining a NYCDOT permit please visit:

http://www.nyc.gov/html/dot/html/motorist/oversize.shtml

Or if you prefer you can contact City DOT at the following address or phone number:
New York City Department of Transportation
Bridges - Truck Unit
55 Water Street,
New York NY 10041
Tel: (212) 839-6341

 

Divisible Loads

Except as noted below under Throgs Neck Bridge, vehicles carrying Divisible Loads that are over 80,000 lbs GVW and vehicles that are less than 80,000 lbs but are NOT in compliance with the State Bridge Formula must obtain a Divisible Load Permit from the MTA before attempting to cross any MTA Bridges and Tunnels facility. Please note that except as noted below under Throgs Neck Bridge, City and State Divisible Load Permits are not valid on MTA crossings. MTA permits are required.

Customers applying for a Divisible Load Permit click here for a PDF Fillable application form (New)

For further information on obtaining Special Handling Permits send an e-mail to cpo@mtabt.org or call 212-360-3000 or Fax 646-252-7135 (Please note that these numbers and e-mail address replaces individual facility numbers.) "



Throgs
Neck Bridge

6 and 7-axle trucks not exceeding 105,000 lbs. GVW with valid City or State Divisible Load Permits and 5-axle trucks not exceeding 102,000 lbs. GVW with valid milk hauling permits are the only divisible loads allowed to cross the Throgs Neck Bridge. They must use the center lane at all times at speeds of no more than 30 mph. This permission may be revoked at any time and for any reason. No other trucks carrying divisible loads are allowed on the Throgs Neck. Trucks with GVW of 80,000 lbs or less and trucks in compliance with the New York State Bridge Formula must also travel in the center lane at speeds of no more than 30 mph on the Throgs Neck Bridge.

 

Vehicle Dimension and Hazardous Materials Regulations

For information regarding MTA vehicle dimension and hazardous material regulations, please click on the following links:
MTA Vehicle Dimensions  (All vehicles not in compliance for dimensions must call phone number of facility listed above.)
MTA Hazardous Materials Regulations  (Please note: The transportation of all hazardous materials is prohibited at the Queens Midtown and Brooklyn-Battery Tunnels.)
Truck Tolls

 

  • Google Translate